RV-8 70cc FLS Instructions
10
MAIN WING SERVOS AND LINKAGES INSTALLATION
Required for this section
Components
Tools
Adhesives/Building Materials
o
Main Wing Panels (2)
o
Aileron Linkage (2)
o
Aileron Servos (2)
o
Aileron Servo Arms (2)
o
18-inch (460 mm) Aileron
servo extensions (2)
o
Flap Linkage (2)
o
Flap Servos (2)
o
Flap Servo Arms (2)
o
9-inch (230 mm) Flap
servo extensions (2)
o
Ball Links (8)
o
M3 x 15 Socket Head Cap
Screw (8)
o
M3 Washer (16)
o
M3 Lock Nut (8)
o
#1 Phillips Screwdriver
o
2.5mm Hex Driver
o
5.5mm Nut Driver
o
Thin CA
o
Blue Thread Lock
o
Servo Connector Safety Clip
Ailerons
⃞
1.
Use a #1 Phillips screwdriver to thread a servo mounting screw into each of the pre-cut
holes in the servo mounting rails in the wing. Remove the screw and apply a small
amount of thin CA to each of the holes to harden the threads cut by the screw. Do not
use CA accelerator. Let the CA fully cure before moving forward.
⃞
2.
Secure an 18-inch (460 mm) servo extension to each of the Aileron servos. Use Flex Servo
Connector Safety Clips (FPZA1040), heat shrink tubing or thread to secure the
connection.
⃞
3.
Insert the aileron servo into the servo bay with the output shaft towards the leading edge
of the wing. Be sure to route the servo lead out of the wing before mounting the servo.
Mount the servo to the wing using the servo mounting screws provided with your servos.
Be sure to install the servos with the long servo extensions in the outside servo openings
of the wing panels (aileron location) and not in the openings close to the root of the wing
panel where the flap servos will be installed.
⃞
4.
Use your radio system to center your aileron servos. Install your aileron servo arm onto
the servo as close to parallel with the hinge line as possible. Apply blue thread lock to the
servo arm screw and fully tighten the screw. If your servo arms have output shaft
clamping screws, apply blue thread lock, and secure them in place at this time.
⃞
5.
Using a pushrod with a length of 2-3/4 inches (70mm), assemble the aileron linkages so
that the total length from center of ball to center of ball is approximately 95mm. Final
length will be adjusted when centering the control surface. Note that the opposite ends
of each aileron linkage have opposite direction threads.
Содержание FeatherLite RV-8 70cc FLS
Страница 1: ...RV 8 70cc FLS ARF and ARFSV Instruction Manual...
Страница 83: ...RV 8 70cc FLS Instructions 79 INNOV A TIONS TM 35 0000 3 5 0 0 0 0 Aura...
Страница 85: ...RV 8 70cc FLS Instructions 81 RV 8 70cc FLS Camouflage Scheme ARMY GROUND EARTH HERE ARMY GROUND EARTH HERE...
Страница 86: ...RV 8 70cc FLS Instructions 82 U S ARMY...
