RV-8 70cc FLS Instructions
28
⃞
2.
Partially install the vertical fin on the tube. Rotate the vertical fin on the tube
approximately 45 degrees away from its final installed position. Connect the servo lead to
the servo extension, and secure it in place using a Servo Connector Safety Clip
(FPZA1040). Continue sliding the vertical fin down onto the tube at the 45-degree angle.
Once the aluminum tailwheel bracket has passed the notch at the bottom of the
fuselage, you can rotate the fin to align it in line with the fuselage. Finish seating the
vertical fin fully, being sure to avoid pinching your rudder servo wires.
⃞
3.
The vertical fin is secured in place by one M3 x 15 socket head cap screw and M3 washer
toward the leading edge of the vertical fin, and by two M3 x 10 socket head cap screws
and two M3 washers through the tailwheel bracket into the bottom of the fuselage.
Secure all three screws in place. If you do not plan on removing the vertical fin, use blue
thread lock when securing the screws.
⃞
4.
Slide the lock collar up to the aluminum tailwheel bracket. Apply blue thread lock to the
set screw and fully tighten.
Содержание FeatherLite RV-8 70cc FLS
Страница 1: ...RV 8 70cc FLS ARF and ARFSV Instruction Manual...
Страница 83: ...RV 8 70cc FLS Instructions 79 INNOV A TIONS TM 35 0000 3 5 0 0 0 0 Aura...
Страница 85: ...RV 8 70cc FLS Instructions 81 RV 8 70cc FLS Camouflage Scheme ARMY GROUND EARTH HERE ARMY GROUND EARTH HERE...
Страница 86: ...RV 8 70cc FLS Instructions 82 U S ARMY...
