Flavor Burst JBT 80FCB-2B, Оборудование, техническое обслуживание и эксплуатация: Руководство

Страница: 49 / 64

48
6. Line the bracket up flush with the top edge
of the freezer and the lip of the bracket over
the edge. Center it between the two
notches on the bracket. Mark the freezer
through the bracket screw holes.
7. Use a 7/32" or 13/64” drill bit to drill four
holes into the freezer for the new screws.
NOTE : DO NOT MAKE A HOLE LARGER
THAN 0.23” DIAMETER.
8. Remove the top panel of the freezer. Use
the 4 screws to attach the bracket to the
freezer and the nylon locking nuts to secure
them from under the freezer panel.
9. Then hang the Jumbo Touch Panel hinges
on the bracket posts. Secure the Jumbo
Touch Panel with the nylon locking nuts
provided.
10. Lift the Jumbo Touch Panel to test the
hinges and stability of the mounting. Make
adjustments as needed.
11. Plug the ethernet cable into the ethernet
gland next to the power cable. Plug the
spout switch into one of the ports at the top
center of the Jumbo Touch Panel. It
doesn’t matter which port; the Jumbo Touch
Panel programming will link to the active
switch during the setup procedure.
26113
26114
26115
26116
26128
26124