Flash Technology FTS 350i-2, Руководство пользователя

Страница: 15 / 16

FTS 350i-2 USER MANUAL
Flash Technology, LLC Revision A – 4/21/2022 15
Table 4-2 – Troubleshooting - Beacon Does Not Flash at Night
Step Check/Test/Action Action
2a Is AC power applied?
Yes
No Go to Step 2b.
Correct problem.
2b
Does beacon flash after being covered for 1
minute? Yes
No Go to Step 2c.
Replace unit.
2c
Is there continuity between the RED and
ORANGE conductors?
--OR
—
Does the beacon respond with a single quick blink
to a button press of 1 on the remote control?
Yes
No Beacon is operational.
Replace the unit.
Table 4-3 – Troubleshooting – Beacon Flashes, But Not in Sync
Step Check/Test/Action Action
3a
Does GPS antenna (located in top of beacon)
have an unobstructed view of the sky? See
Section 2.1
Yes
No Go to Step 3b.
Correct problem.
3b
After 10 minutes of power on, is there continuity
between the RED and ORANGE conductors?
--OR
—
Does the beacon respond with a single quick blink
to a button press of 1 on the remote control?
Yes
No Beacon is operational.
Replace the unit
Table 4-4 – Troubleshooting - Beacon Flashes in Daytime
4.3 BEACON REPAIR PROCEDURES
Warning: Read the Personnel Hazard Warning (page 3) now. Remove power from all wiring and circuitry before
installing or performing work on the beacon. It is the responsibility of the installer to comply with all applicable
electrical codes.
Note: While performing the following steps, check for any loose connections and other damaged components.
4.3.1 REPLACE THE BEACON
FTS 350i-2 Part Number: F1350200
BEACON REMOVAL
Disconnect the beacon’s cable pigtail from the power source and any monitoring equipment. Unfasten the
hardware that holds the 350i unit to the structure or mounting bracket. Remove the beacon.
BEACON REPLACEMENT
Refer to Section 2 (page 8).
Step Check/Test/Action Action
4
Is the light collector (located near marked corner
of beacon) obstructed? Check for any foreign
matter on top of beacon.
Yes
No Correct problem
Replace unit