17
COMM MODE: COMMUNICATION
Link
watch data to PC
Learn
new sensors
Change
COMM
address
Setup
watch from
www.fitsense.com
L
EARNING A
S
ENSOR
The watch will listen only to sensors it owns. If you are using a new watch, foot pod or
heart rate monitor, the watch needs to learn these sensors.
Foot Pod
1. Enter
COMM
mode on the watch.
2. Press the foot pod button three times quickly.
3. When the foot icon appears in the lower left quadrant, the watch has learned your
foot pod.
Heart Rate Monitor
1. Enter
COMM
mode on the watch.
2. Put your heart rate monitor on.
3. When the heart icon appears in the lower left quadrant, the watch has learned the
ID of your heart rate monitor.
O
FFLOADING YOUR
W
ATCH
(U
SING
O
PTIONAL
N
ETLINK
)
1. Make sure your
Netlink
Software is running on your PC and your
NetLink
device is
plugged into the serial port on your PC.
2. Enter
COMM
mode.
3. Your watch will automatically connect to the
NetLink device. The blue light on the NetLink
device will begin blinking when it connects to
the watch. When the PC begins
communicating with your watch, the blue
light will stay on continuously. If the light
continues blinking, your PC software may
not be running.
4. "PC” will appear in the lower left quadrant.
5. The entire contents of your
LOG
including splits, your chart data, and all of your
customized information (including CalVals, weight, etc.) will be sent to the PC. A
normal offload will last 10-30 seconds.
6. The chart data will be cleared from your watch memory after offloading.
LOG
data will remain in the watch memory unless you choose to remove it.
Содержание FS-1
Страница 1: ......
Страница 2: ......
Страница 4: ...WATCH FOOT POD NETLINK OPTIONAL ...
Страница 33: ...FitSense 212 Worcester Street Wellesley Hills MA 02481 1 800 419 3667 www fitsense com version1 1 2 08 01 ...