EN
13
NOTICE – Risk of Damage to Mate-
rial and Property
■
Non-rechargeable batteries are not to
be recharges.
■
Rechargeable batteries are to be
removed from the training computer
before being charged.
■
Always replace all batteries. Do not
use di
ff
erent battery types, brands or
batteries with di
ff
erent capacities.
■
Do not expose the training device to
extreme temperatures, strong temper-
ature
fl
uctuations, persistent moisture
or wet conditions, direct sunlight or
impacts.
Mounting the Seat
1. Unscrew the stoppers at the rear of
the device using the tool which is also
supplied (
Picture B
).
2. Place the seat (
9
) with the castors on
the rails and slide it forwards (
Picture
C
). When you do this, make sure that
the seat is attached the right way
round: The raised part of the seat
must be pointing forwards, the hollow
part backwards (see also front cover
and overview picture).
Positioning the Device
PLEASE NOTE!
■
Always place the device on a dry,
fl
at,
stable and non-slip surface. Delicate
fl
oor coverings should be protected
with a non-slip mat or similar.
■
Some parts of the device are greased
or oiled. While moving the device do
not touch the pulleys / shafts.
Depending on your height, leave enough
space on all sides of the training device
(at least 1 metre to the sides, 2 metres
above it), so that there is enough room to
move during training (
Picture D
). In addi-
tion, the clearance space needs to be at
least 0.6 m larger than the exercise area
in the direction from which the training
device is accessed. The clearance space
must include the space required for an
emergency dismount. If training devices
are set up in the immediate vicinity of one
another, they can share one clearance
space.
Setting Up the Device for Training
1. You can use the castors (
10, 15
) to
push the collapsed training device
(
Picture F
) to the location you want.
Hold it by the middle handle (
8
).
2. Make sure that there is enough space
around the training device so that you
cannot bump into walls, furniture, etc.
during the workout.
3. Open up the training device:
–
grab hold of the middle handle;
–
grip the bottom part with your other
hand and slide it back away from
you until the training device is
horizontal on its feet (
11
);
–
close the snap locks (
12
) on both
sides;
4. if necessary, insert the handle (
5
) into
the holder (
3
).
Storing the Device After Training
1. Insert the handle (
5
) into the holder (
3
).
2. Collapse the training device:
–
release the snap locks (
12
) on both
sides;
–
slide the seat (
9
) all the way to the
end;
–
hold the training device by the
middle handle (
8
) and pull it up until
it stands upright on its own.
3. Use the castors (
10, 15
) to push it to
the position you want. Hold it by the
middle handle.
4. Check that the device is positioned
securely.
