Assembly instructions Rev 7.1
6
This document is the property of Fischer Connectors.
This document must not be reproduced or distributed, in whole or in part, without prior written permission of Fischer Connectors.
Position the O-Ring Seal “G” on
the Potting Set Body “H” then
slide the Potting Set Body “H”
into the Connector Body "B".
Be careful to the orientation of
the back body.
Screw by hand the Rear Nut “J”
on the Connector Body “B”.
Screw the Rear Nut "J".
Recommended torque : 5.0 Nm
Torque wrench [5Nm]
Size 16
Counter piece:
receptacle FO2/4
Crimp the ground contact onto
the Potting Set Body “H” using
the crimping sleeve”I” .
Find tools drawing in
appendixes.
Slide the Shrink Tube "K" until the
end of the shrink tube bottoms
against the Potting Set Body “H”
as shown on the left picture and
heat it.
Heat gun
Shrink tube operating
temperature Range : -
55°C to 110°C..
