Placement and Use of Components
CM6300
RPS Touch and RPS (Remote Paging Sensor)
The RPS is an optional feature. The car call/RPS feature uses a small sensor that is mounted on the inside
of your windshield.
Important: When using the RPS Touch, you cannot use the LED port or
Secure Valet Switch.
RPS Touch (Remote Paging Sensor)
The new RPS touch has multiple features including: remote paging, 4 digit pin unlock/disarm, and arm/
lock. All features are operated with a simple touch of the sensor.
Please program Option 3-16 to Setting 2.
RPS Touch and car call functions do not require programming, however in order to unlock/disarm your
vehicle you must program a 4 digit passcode (numbers 1 through 10 only) using the instructions below:
STEP 1:
Choose your RPS Touch 4 digit code. ‘0’ is not available.
STEP 2:
Turn ignition to the ‘ON’ position and leave driver’s door open.
STEP 3:
Hold your finger over the ‘Red Circle’ icon for 2.5 seconds.
STEP 4:
When the siren chirps and LEDs flash in a circular pattern, tap on your first number. (Hold the
number for 2.5 seconds to choose 6 through 10.) After choosing your first number you will get one siren
chirp and LEDs will flash in a circular pattern.
STEP 5:
Repeat Step 4 until all four digits are set. You will get 1 siren chirp and 1 parking light flash.
Repeat Steps 2 - 5 if you get 3 chirps and light flashes. Your RPS Touch is now programmed.
Alarm rearm and lock
To rearm hold your finger on the ‘Red Circle’ for 2.5 seconds.
Alarm disarm and unlock
To disarm hold your finger over the ‘Red Circle’ for 2.5 seconds. Once the LEDs start their circular pattern,
enter your 4 digit code. (Refer to Step 4 above.) Two seconds after entering the 4th digit, your system will
disarm.
CM6300
Install Guide
Alarm System
www.firstechonline.com | www.compustar.com
Copyright 2012 Firstech, LLC.
Page 7
