Pin 11 Black [POC 5] – Auxiliary 2 250mA negative (-) output. This is an optional output that will provide a
programmable output to trigger sliding doors, power windows or whatever other features you’d like.
Pin 12 Brown/White - This wire looks for key sense negative (-) input. The proper wire will
show a (-) trigger only when the key is in the ignition. The purpose of the key sense is to
prevent the system from passively arming or relocking while the key is still in the
ignition.
Pin 13 Orange [POC 6] - Factory Arm 250mA negative (-) output. This is an optional output that will
provide a (-) pulse during lock, after crank and again after the ignition shuts down.
Pin 14 Pink - Closed Loop negative (-) input. This wire acts as an instant trigger when separated from
ground (-). It is most commonly used to protect headlights or trailers.
Pin 15 Orange/White [POC 7] - Factory Disarm 250mA negative (-) output. This is an optional output that
will provide a (-) pulse during unlock and prior to the ignition turning on.
Pin 16 Yellow/Black - Tach Sense input. Connect this wire to a tach source for Ignition controlled door locks.
This is option 1-09: setting 3. The doors will lock once the rpms double from what they are
programmed at.
Pin 17 White [POC 8] - Horn honk 250mA negative (-) output. This is an optional output that will pulse the
factory horn. The proper wire will show ground (-) while the horn is sounding. To change horn
output settings, review Options 3-8 and 3-9.
Pin 18 Gray/Black – Hood Pin negative (-) input. This input is a safety shut down and alarm trigger. It
triggers the alarm if the hood is opened while the it is armed. You can connect this wire to the hood
pin supplied with this kit, or to a wire in the vehicle that shows (-) only while the hood is open.
Pin 19 Violet [POC 9] - Auxiliary 1 250mA negative (-) output. This is an optional output that will provide a
programmable output to trigger sliding doors, power windows or whatever other features you’d like.
Pin 20 Brown - Siren 12V positive (+) output. Connect this wire to the (+) wire located on the siren. To
change siren output settings, review Option 3-7.
CM6300
Install Guide
Alarm System
www.firstechonline.com | www.compustar.com
Copyright 2012 Firstech, LLC.
Page 16
