First Products UA60T, Руководство оператора и список запчастей

Страница: 19 / 54

First Products UA-60T Operator’s Manual
Maintenance bbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbb
18
11.7-
12.0
0-25%
14.4
volts/4
amps
3 Hours
11.7 or
less
0%
14.4 volts/
2 amps
6 Hours
or More
Check Hydraulic Oil Level
Service Interval: Every 40 hours
Hydraulic Oil Level
1. Stop engine and wait for all moving parts to
stop. Make sure unit is on a level surface.
2. The hydraulic reservoir is located under the rear
left cover of the machine. Unscrew the cap and
clean the dipstick.
3. Reinsert the dipstick. Do not screw into place.
Remove the dipstick and read the oil level.
4. If the oil level is low, fill to the “FULL” mark,
Figure 15.
Do Not overfill.
Figure 15. Dipstick Markings
5. Use only A68 Hydraulic Oil or appropriate
substitute.
Check Tire Pressure
Service Interval: Every 40 hours
1. Stop engine and wait for all moving parts to
stop.
2. Check tire pressure and make any necessary
adjustments.
Check for Loose Hardware
Service Interval: Before each use or daily
1. Stop engine, wait for all moving parts to stop,
and remove key.
2. Visually inspect machine for any loose
hardware or any other possible problem.
Tighten hardware or correct the problem before
operating.
Checking Rotor Shaft Tines
Service Interval: Before each use or daily
1.
Ensure the rotor shaft is off the ground with the
lift cylinder completely retracted and engage red
handled cylinder lock bar.
2. Stop engine, wait for all moving parts to stop,
and remove key.
3. Clean rotor and shaft free from debris.
4. Inspect for loose of broken tines.
Figure 16. Rotor
5. Tines are assembled as shown in Figure 16. The
tines are removed and installed using an extra
deep impact socket (AE60T003), provided with
shaft.
Torque tines to 210 ft-lbs.
For safety reasons, each maintenance
operation must be performed with the
machine off and key removed.