Firetide HotPort 5020-LNK, Руководство по установке

Страница: 37 / 46

Troubleshooting
31
2. Click
New Scheduler
.
a. Select Upgrade.
b. Select the time: Later. Use the calendar to a future date and time.
c. Click the tab to select a device type (HotPort Nodes for a mesh
network, HotPoint Nodes for access points, or FMC for mobility
controllers), and then select the mesh or device by ID or name.
Note:
The system selects all nodes within a mesh for simultaneous upgrade
because all of the nodes have to run the same firmware. If a node should not
receive the upgrade image, you can remove the mark from the upgrade check
box.
d. Select
Activate Later
.
e. Select the upgrade image.
3. Click
OK
.
The “upgrade complete” message means that the image file is on the node
and is valid. You can then activate a few nodes at a time until all of the nodes
are running the same firmware version.