Firetide HotPort 5020-LNK, Руководство по установке

Страница: 14 / 46

Before you permanently install
8
Switch
To configure an edge node and do tests with HotView Pro software:
1.
Put the nodes on a table.
2. Attach the Ethernet cable from the administrator computer to the server
node.
Note.
The administrator computer must have an IP address on the same subnet
as the node. The default IP address is 192.168.224.150.
3. Attach the power cables to power sources as shown in the previous figure.
Caution!
You must use the power supply that comes with the node. If
you use a different power supply, you void the product warranty.
The power LED comes on. The node boots and is ready to use in one minute.
4. Attach one antenna adapter and then staging antenna to Radio 1/Antenna
connector 1 on each node.
5. Download and configure HotView Pro. See “Installing and configuring
HotView Pro software” on page 6.
6. Go to
Mesh > Add Mesh >
login with the default user name and password.
7. Make sure the nodes are visible in HotView Pro.
The system should prompt you to set the country code.
8. Set the country code for the node to change the device from a low-power,
low range setting to a correct full-power operational mode.
Caution:
Make sure you configure the device for the correct country. If
you do not configure the country correctly, the device might operate in a
manner that is not legal or create problems with other wireless devices.
!
!