Firetide HotPort 5020-LNK, Руководство по установке

Страница: 19 / 46

HotPort 5020-LNK node installation
13
Preparing a node for outdoor installation
It is easier to install all devices to one object, such as a pole, and then attach the
pole assembly to the roof. If you attach the devices to a pole attached to the roof
top, factors, such as weather, can make the installation more difficult and
dangerous.
Note:
Install the antenna at the correct elevation recorded in the site survey
report. The installation elevation can be higher or lower than the HotPort
because the elevation is related to the link path calculations.
Warning!
Only use antennas that are rated for outdoor applications.
W
arning!
Failure to obey these instructions might result in severe
personal injury including electrical shock or permanent damage to
equipment.
Warning!
Make sure that all safety equipment is in good condition. Do
not use broken or damaged tools or equipment. Always use safe work
practices and obey all local and national guidance for earth ground
requirements and electricity.
For this procedure you need to have a copy of the antenna elevations from the
site survey report and all tools.
To prepare a node for outdoor installation:
1.
Make sure that you use the outdoor antennas that come with the HotPort
5020-LNK solution.
2. Remove the mount bracket from the node.
a. Use the Phillips screwdriver to loosen the four captive screws (two
on each side).
Mount bracket
Captive screws
b. Remove the outer mount bracket from the hooks of the mount plate.