Firetide HotPort 5020-LNK, Руководство по установке

Страница: 12 / 46

Before you permanently install
6
You can install the antennas on a pole or to a wall. Each antenna weighs 0.8
kg (1.8 pounds) without clamps.
Vertical polarization for this antenna is the left connector.
For electrical and mechanical specifications, see the
Firetide Antenna and
Accessory Guide
s
.
Test before you install
You should set up and test the nodes indoors on a table before you install
them in permanent locations.
The benefits of tests before you install include:
• Make sure all of the equipment works before you install it
• Consistent settings across nodes to reduce software configuration
errors in the field
Types of tests to do:
• Power on each device
• Attach the staging antennas and make sure you can see the
devices in HotView Pro management software
• Data and other application throughput tests to make sure the nodes
can send and receive data
• Learn to use the radio alignment tool
• Train installation personnel
Required tools that are not included
You need a computer that has HotView Pro network management software
10.
15
.
0
.0 or later installed.
Installing and configuring HotView Pro software
HotView Pro does not support
the following features in a 5020-
LNK mesh
SNMP, Mobility Calibration Tool,
S
pectrum Analysis Tool, Gateway
Server and Gateway Server
Redundancy, Mobility, Radio
Analysis Tool, Static and
Automesh routing, Link
Elimination, Multicast Groups,
Ethernet Direct, Ethernet Loop
Detection, External VRRP Support,
and End to End Security
If you use this procedure, you can manage the pair of nodes from HotView
Pro. The computer used for management if configured correctly will not
require a separate management license because the licenses will be stored