FireplaceXtrordinair 35 Custom Builder, Руководство пользователя

Страница: 46 / 48

4 4
Optional Equipment
(for qualified installers only)
Travis Industries 9 3 5 0 8 1 1 6 0 3 1 0 0 0
4 Attach the on/off wires to the valve following the directions below.
Attach these two
wires to the front of
the gas control valve.
VALVE
“ON/OFF
”
5 Install the electrical connection to the fireplace following the directions below.
a b
Insert the sheathed cable from the power source through
this cable clamp. Once the wires are attached, tighten
the clamp to secure the cable.
Replace the
cover removed
in step "a".
Attach the common (white), ground (exposed or green)
wires, and hot (black) wires from the power source to the
electrical connector (attached to the fireplace).
c
d
Standard
Screwdriver
Remove the cover from the
fireplace junction box.
1/4" Nutdriver
WARNING: Make sure power is
off from the power lead before
conducting any wiring.
Electrical
Connector
6 If using the modulating remote, install the heat shield following the directions below.
Place the top portion of the heat shield over the lower portion.
Bend the tabs over to lock the two pieces together.
a
Position the receiver heat shield at the front of
the fireplace near the gas control valve.
b