Firenzo kompact ag, Инструкция по установке и эксплуатации

Страница: 40 / 45

Kompact RU Installation Version 14/4/14 40
14. OPERATING INSTRUCTIONS
KEEP THIS BOOK IN A SAFE PLACE.
FIRST BURN
On the INITIAL LIGHTING only, the high temperature paint finishes used on
your heater will give off smoke and odour for several hours. As this is a
temporary condition, open doors, windows, etc. to give adequate ventilation
until passed.
1. Prepare fire by placing crumpled paper in middle of firebox. Do not use a
grate, or elevate fire. Build fire directly on floor of firebox.
2. Pull air control knob out fully for high (this is the small knob to the right of
the door)
AIR CONTROL OUT = HIGH.
AIR CONTROL KNOB IN = LOW
3. Arrange dry kindling in “tepee” style with larger pieces standing up on each
side. Ignite paper leaving door ajar until kindling is alight.
4. When vigorous flaming of the kindling subsides and embers begin to
appear, reload with larger wood, placing them in a side to side configuration.
5. Open door carefully and place small pieces, then larger logs on top.
6. Close door tight and leave Air Control on HIGH for some 50 minutes. The
value in establishing this technique is that you are providing an excellent base
for burning your wood effectively.
7. When a good fire is established move air control to middle position. DO NOT
IMMEDIATELY SHUT THE HEATER TO LOW. Remember to close the air
control gradually to your desired level of heat output. It is better to take 3-4
adjustments to get to the low setting (extended burn).
RELOADING
NOTE: It is necessary to move the Air Control to HIGH before opening the
door.
Never open the door when a vigorous fire is in progress. Wait until the flames
have subsided and the wood has broken up into glowing embers. Reload with
dry logs, placing them in a side to side configuration.
Leave the air control in the HIGH position for 10 to 15 minutes or until the
flames begin to subside. This shows that the initial highly volatile wood gases
have been driven off and the heater will be able to maintain an even burning
rate.
Normally a light load of fuel will stabilize quickly but a full load will take longer.
Once the burning rate has stabilized move the Air Control to a medium position.