Firenzo kompact ag, Инструкция по установке и эксплуатации

Страница: 25 / 45

Kompact RU Installation Version 14/4/14 25
11. ASSEMBLY INSTRUCTIONS (Built-In Fire Canopy)
1
Carefully remove all packaging.
2
If installation is into a BUILT-IN CANOPY: Construct the canopy box and
install into framework following the guides on pages 12 - 20 as applicable.
3
Before insertion into the Built-In Fire Canopy
place 25mm white Kaowool
blanket (supplied) on top of casing. Diagram page 23.
4
Slide the firebox into the opening so that the outer casing return folds are
flush with the face of the built-in canopy.
5
it is important to anchor the insert down in case of movement. Restraint
points are provided through the fires two front legs.
6 Install Flue as per instructions on pages 8, 9 & 25 if using a Built-in fire
canopy (zero clearance box).
7
As this fire sources its combustion air from the chimney cavity/enclosure,
the fire MUST be sealed around the front between the casing and built-in
canopy. This is achieved by packing the yellow ISB insulation supplied
between the casing and the built-in canopy at the FRONT ONLY to
maximum depth of 80mm. Diagram page 23
UNDER NO CIRCUMSTANCES SHOULD THE AIRPORTS ON THE
SIDE OF THE HEATER BE RESTRICTED. Refer diagram page 23.
The fire sources its combustion air from the false chimney cavity, not
from the room where the fire is installed. See Page 17 Diagram 13 for
ventilation requirements. Failure to ensure this air supply will starve the
fire of air and lead to poor performance.
8
Assemble and fit the fascia as per instructions on pages 26 - 38.