Finn HydroSeeder T120GN, Руководство оператора

Страница: 38 / 87

32
TROUBLE SHOOTING YOUR HYDROSEEDER
®
(CONTINUED)
:
Problem Probable Causes Suggested Solutions
Pump worn. Reset pump tolerance page 22.
Suction partially plugged. Clean out machine see page 16.
Nozzle worn or plugged. Clean nozzles, replace if
necessary.
Fertilizer. Change type.
Clutch slippage. Readjust clutch page 23.
VALVE:
Valve stuck: Frozen. Thaw out ice, lubricate. Leave in
discharge position during storage.
Constant plugging
during operation.
Foreign material in slurry. Drain clean out tank. Check storage
for foreign materials.
Constant plugging
during loading and
discharge.
Loading Hydroseeder
before tank is half full of
water.
Reinstruct your operator. (See page
11).
Incorrect loading
procedure.
Review loading procedure page 11.
Improper operation by
operation.
Reinstruct your operator. (Review
Operators' Manual).
Clutch slipping. Readjust clutch see page 23.
Not moving valve handle
far enough.
Valve should be fully open.
Machine not being
flushed out prior to
reloading.
See page11.
Machine not being run at
correct RPM during
loading.
Reinstruct your operator. (See page
11).
Extension hose plugs
after use.
Letting water run out,
leaving wood fiber mulch
to dry out.
If hose to be uncoupled, seal ends
to keep water in hose and prevent
wood fiber mulch from drying out.
CLUTCH:
Does not pull load or
overheats.
Out of adjustment. Readjust clutch, instruction on page
23.
Jumps out of
engagement.
Too loose or too tight. Readjust clutch, instruction on page
23.
CLUTCH CONT’D:
Pump looses prime -
lacks distance - leaves
excessive amount in
tank (100 gal (378 liters)
or more).