Finn HydroSeeder T120GN, Руководство оператора

Страница: 27 / 87

21
3. Check the level in the hydraulic oil reservoir - maintain level at sight gauge.
4. Check the clutch adjustment to insure that it “snaps” in and out of engagement. Adjust the clutch with
the engine off.
5. Check the anti-freeze in the radiator.
6. Inspect the slurry-tank for build up of residue in the suction area and clear if necessary.
7. Check and clean engine radiator. Flush with clear low pressure water and blow dry with compressed air.
Do NOT use high pressure water spray.
SEASONAL AND WINTER STORAGE MAINTENANCE:
1. Drain the slurry tank of all water prior to storage and leave the drain plug disconnected.
2. Park unit in suitable location and chock wheels to prevent inadvertent movement.
3. If possible cover machine with tarp or park inside of an enclosure.
4. Store the HydroSeeder
®
with all slurry valve handles in the open position. To prevent damage from
freezing, it is advisable to remove all slurry valves and store in a heated area.
5. Pour one quart of mineral oil or environmentally safe lubricant into the pump housing and spin pump by
hand to prevent rust in the pump. Remove drain plug.
6. Chip and steel brush any interior rust spots in the slurry-tank and touch up with paint. See numbers 2
and 3 in Maintenance Section (IV) of the Safety Summary Section page 4.
7. Lubricate all fittings.
8. Check anti-freeze in radiator.
9. Lubricate equipment again just prior to starting operation after storage.
10. Change hydraulic oil and filter. (400 hours)
11. Disconnect battery cables. In cold weather, remove battery and store in safe warm place.
12. Add fuel stabilizer to fuel tank.
HYDRAULIC SYSTEM:
The hydraulic system on your Finn HydroSeeder® is designed to give trouble free service, if maintained. The
most important areas of maintenance are the hydraulic oil and filtration. The reservoir holds 19 gallons of ISO
Grade 46 hydraulic oil. The hydraulic oil should be replaced per the lubrication schedule or if the oil becomes
milky or it gives off a burnt odor. The hydraulic oil filter must be replaced on schedule with a 25 micron absolute
filter - Finn part #021618. The hydraulic system relief is factory set at 2,100 psi.