Finn HydroSeeder T120GN, Руководство оператора

Страница: 21 / 87

15
3. Piping System Cleanout Procedure (Purging Line):
A. Remove discharge nozzle and gasket from discharge boom.
B. Aim discharge boom assembly into an open area away from any persons, obstructions or high
voltage power lines.
C. Open discharge valve and close recirculation valve.
D. Increase engine speed to approximately 1/2 to 3/4.
E. Engage clutch with a firm snap. Do NOT slip clutch.
F. When discharge stream is clear, open recirculation valve and close discharge valve. After
recirculation stream is clear disengage clutch.
G. Replace gasket in discharge boom.
4. Continue filling tank with water.
5. Increase engine speed to full RPM.
6. Start loading dry material, loading the lightest material first. Agitator control should be in full reverse
for mixing.
A. Seed - Cut the seed bag and dump contents into the slurry tank. (When using inoculant, add
it in the tank along with the seed.) When using quick swelling seeds load them just prior to
application.
B. Wood Fiber Mulch - Empty the entire bag in or cut bag and drop in the sections of fiber. The
amount of mulch to be used should be loaded by the time the water level is at 3/4 full. If
agitator stalls or a high pitch squeal comes from the hydraulic system, reverse agitation to
forward for a moment to clear the obstruction, then return agitation to reverse.
CAUTION: Hydraulic system will overheat if agitator shaft is jammed for
extended period. This will damage hydraulic oil and system
components.
C. Fertilizer - Stand over hatch opening and drop the bag onto the bagcutter. Grasp both ends of the
bag and dump material.
D. All other additives - Consult with manufacturer for proper loading technique.
7. When all materials are loaded and in suspension, and the tank is full, move the agitator to neutral then
full speed forward to insure all material is mixed. It may be necessary to change the agitator direction
more than once to insure a thorough mixture.
8. After material is thoroughly mixed, slow agitator in forward direction to 1/2 to 3/4 speed or enough to
create movement in all of the corners of the tank. Do not over agitate the slurry. Always discharge the
material with the agitator control in forward position.
9. Close the hatch lid on the slurry tank.
NOTE: The slurry should not be recirculated for more than 15 minutes prior to
discharge to reduce wear and keep seed from swelling.
NOTE: If foaming occurs, reduce agitator speed.