Finn HydroSeeder T120GN, Руководство оператора

Страница: 16 / 87

10
TWO VALVE OPERATION:
The T120 HydroSeeder® is equipped with two independently operated ball valves to control slurry flow. One
is located in the recirculation line below the platform, and the other is located in the discharge line above the
platform. The recirculation valve is open when the handle is in line with the valve ports and is closed when
the handle is at a right angle to the valve ports. The discharge valve is open when the “v” notch in the foot
pedal is in line with the valve ports and is closed when the “v” notch is at a right angle to valve ports.
WARNING: Never engage the slurry pump clutch when both valve handles are
positioned as shown Figure 3. Both valves are closed and will
result in extreme heat generation that will cause damage or bodily
injury if the slurry pump is running.
Figure 3 - NEVER Engage Slurry Pump Clutch w/Both Valves Closed
1. DISCHARGE THROUGH BOOM:
Flow is through boom with no flow through closed recirculation valve (Figure 4). Flow through boom is
controlled by engaging and disengaging slurry pump clutch. Do not use the discharge valve to control
distance. Valve should be either completely open or completely closed. Control the spray volume and
spray distance by adjusting the engine RPM.
2. EXTENSION HOSE THROUGH BOOM:
Flow is through boom with no flow through closed recirculation valve (Figure 4). Extension hose is
connected to boom and flow is controlled by engaging and disengaging pump clutch, or controlling the
speed of the engine.
DANGER: Do not use remote valve in this application.
฀
฀
฀
฀