Finn HydroSeeder T120GN, Руководство оператора

Страница: 37 / 87

31
TROUBLE SHOOTING YOUR HYDROSEEDER
®
:
Problem Probable Causes Suggested Solutions
LEAKS:
Tank bearing Leaks. Lack of lubrication - seal
worn.
Replace seal and follow lube
schedule.
Bolts not tightened. Tighten uniformly to 25 ft. lbs.
Properly.
Pressure Clamps. Rubber seal cracked,
pinched or torn.
Replace, always grease seal before
clamping shut.
Suction. Rubber seal cracked,
pinched or torn.
Replace, always grease seal before
clamping shut.
Discharge Swivels. Not greased often
enough.
Rebuild swivels w/repair kit (part
#6969, 2 required).
Pump Shaft. Pressure lubricator not
serviced.
Replace pump seal, service
pressure lubricator daily.
Pump Suction Cover. Cover O-Ring bad. Replace cover O-Ring, use grease
when replacing.
Discharge Boom or
Nozzle Camlock
Fittings.
Worn or no gasket. Replace gasket.
MACHINE JUMPS DURING OPERATION:
Agitator. Agitator bent by heavy
object falling on it.
Straighten agitator or shim, so it
runs true.
Bent paddles. Loading wood fiber mulch
into tank before tank is
half full.
Straighten agitator paddle, realign
agitator to run true.
FOAMING OF SOLUTION AND LACK OF DISTANCE.
Pump looses prime -
lacks distance - leaves
excessive amount in
tank (100 gal (378
liters) or more).
Sucking air in suction
lines.
Straighten agitator or shim, so it runs
true.
Air entrainment. See page 27.
Low engine RPM. (Below
2900 RPM-No load)
Check throttle cable and linkage,
See authorized engine dealer.
Soft water. Slow the agitator.
Too much agitation. Slow the agitator.