22
AT THE END OF THE WORK
At the end of the work, and before carrying out any type of
maintenance, perform the following operations:
1. Release the dead man's lever (1) (
Fig.1
) to disable the brush
motor and the pump. The vacuum motor will also stop working
after a determined lapse of time.
2. As soon as the vacuum motor switches off, de-activate the
device, using the main switch (2) (
Fig.2
).
3.
Lift the squeegee from the floor.
4. Lock the control handlebar, push the steering column control stop
lever (3) in the direction indicated by the arrow (
Fig.3
).
5. Turn the control steering column to the vertical position (
Fig.4
).
ATTENTION:
During this operation, do not rest your foot on
the appliance.
6. When the handlebar is in the vertical position, release the stop
lever (3) to lock the handlebar (
Fig. 5
).
7. Tilt the machine and move to a suitable place for carrying out
maintenance work (
Fig.6
), then complete the procedures listed
in the paragraph “
RECOMMENDED PERIODIC MAINTENANCE
OPERATIONS
” in the columns “AT THE END OF THE WORK”.
5. Turn the control steering column to the vertical position (
Fig.4
).
ATTENTION:
During this operation, do not rest your foot on
the appliance.
6. When the handlebar is in the vertical position, release the stop
lever (3) to lock the handlebar (
Fig. 5
).
7. Tilt the machine and move the unit into a suitable place for
discharging waste water. Empty the recovery tank (refer to
“
CHECKING AND CLEANING THE RECOVERY TANK
”) (
Fig. 6
).
ATTENTION:
The place this operation is carried out should
comply with current environmental protection regulations.
The appliance must not be
transported or parked in its idle
position when the solution tank
and recovery tank are full.
3
5
6
4
3
5
6
4
2
3
1
2
3
1
OFF