Fimap 109070, Руководство по обслуживанию

Страница: 78 / 104

Pressure Control Microswitch
The pressure control microswitch is mounted on a bracket. It intervenes if the motors have a too low absorption
to prevent the scrubdeck actuator from continuing to push. If the pin falls below its limit, the micro opens and
stops the actuator.
6.7 Adjustments
6.7.1 50 BTO Brush Deck
The scrub deck is tilted in the transverse direction and should be adjusted longitudinally inclined to the machine
so that the pad evenly lean to the ground and perform its function properly.
Procedure:
ˆ
Remove the Pad from the deck.
ˆ
Lower the deck so that the pad rests evenly and parallel to
the ground.
ˆ
Check the flatness of the support surface with a bubble on
both sides of the base.
ˆ
Use the fixing screw of the upper right arm and fix the
adjustment by tightening the fixing nut.
6.7.2 Orbital Brush Deck Actuator
(see section 4.7.2 at page 62 )
6.8 Disassembly
6.8.1 50 BTO Brush Deck
Close the water, lower the brush deck and switch off the machine.
Remove the batteries, and disconnect the motor power connector.
Remove the solenoid valve support screw (A) and disconnect the
water hose (B).
Unscrew the right and left screws (C).
78