Filtration Group PiW 2175, Перевод оригинальной инструкции

Страница: 28 / 60

Page 8
Translation of the original instructions PiW 2175, Filtration Group GmbH, 28.06.20, Mat. No. 72348069, Version 04
12.1 Replacing the coalescer element
DANGER!
The coalescer is pressurised!
•
First relieve the pressure!
• Then open the coalescer!
IMPORTANT!
Danger to the environment!

Risk of damage to the environment.
•
Recover any leaking fluid in a suitable
vessel.
•
Dispose of the spent filter element in a
manner which does not pollute the
environment and in accordance with official
regulations.
•
Shut down the unit.
• Drain off all the water (oil can also be drained off via the
water drain if necessary).
• Take steps to prevent the unit from being switched on
again by unauthorised persons.
•
Wear protective clothing and equipment appropriate to
the hazard potential of the medium (e.g. eye protection,
protective clothing, protective gloves, safety shoes, etc.).
•
Completely discharge the housing.
• Unscrew the cover screw (1) and remove the cover (2).
• Remove the coalescer element (3) from the filter
housing.
• Inspect the seals for damage and if necessary replace.

The order number of the replacement element must
match the order number of the coalescer element that
is replaced.
• Push the new coalescer element over the spigot in the
filter housing.
• Close the water drain.
•
Mount the cover and tighten the screw (30 Nm).
• Start up the coalescer again.
•
Observe the coalescer.
Does it operate normally?
Fig. 8: Replacing the filter element
Fig. 9: Replacing the filter element (marine version)
12.2 Inspection and maintenance schedule
The necessary inspection and maintenance
work is dependent on the particular
application.
Please consult the manufacturer if
necessary.
The owner is responsible for preparing an
inspection and maintenance schedule.