Fieldmann FZN 4002 B, Руководство пользователя

Страница: 14 / 27

EN
PETROL-POWERED HEDGE TRIMMER USER'S MANUAL
15
CHECKING THE AIR FILTER
Check the air fi lter to be sure that it is clean and in good condition.
Loosen the bolt on the air fi lter cover, remove this cover and then check the fi lter. If necessary, clean or
replace the fi lter.
6. STARTING THE ENGINE
WARNING! The trimmer blades may move when starting the engine.
Make sure that the trimmer blades cannot come into contact with any object. Make
sure that there are no unwanted persons in the work area. These persons would be
subject to a risk of serious injury.
STARTING A COLD ENGINE
Fig. 4
Fig. 5
1. Set the engine switch to the ON position (Fig. 4, point 1)
2. Press the fuel primer bulb (Fig. 5, point 1) several times.
3. Set the choke lever to the CLOSE position (see Fig. 5, point 2)
3. Place the hedge trimmer fl at on the ground so that it is stable and pull on the handle of the starting cord
until the engine shows signs of attempting to start. Initially pull the starter winding cord slowly until you feel
resistance and then pull on the cord strongly. Hold the cord as it winds back into the starter and allow it to
wind on gently and slowly.
4. At this point, set the choke lever back to the OPEN position (Fig. 5) and start the engine by repeatedly pulling
on the starting cord.
ATTENTION! Spinning the engine for too long with the choke lever in the CLOSE position will result in
fl ooding of the engine and problems with starting it up.
5. Prior to starting work, leave the engine to warm up for a few minutes to get up to operating temperature.
Before using | Starting the engine