Fieldmann FZN 4002 B, Руководство пользователя

Страница: 15 / 27

EN 16
FZN 4002 B
STARTING A WARM ENGINE
1. Set the engine switch to the ON position (Fig. 4, point 1)
2. Pull on the handle of the starting cord until the engine starts up
DO NOT USE THE CHOKE!
ATTENTION! In the event that the fuel in the fuel tank was completely used up, after pouring in fuel, repeat
the steps for STARTING A COLD ENGINE.
WARNING! Be careful that the blades do not come into contact with foreign objects such as metal wires or
grates that could damage the blades or the drive. In the event that the blades are blocked or jammed against
an obstacle, immediately stop the engine. Only then release the blocked power tool.
Check that the trimmer blades are not moving when the engine is idling.
STOPPING THE ENGINE
Set the engine switch to the OFF position (Fig. 4)
7. USING THE HEDGE TRIMMER - TRIMMING
ATTENTION! In an emergency situation, stop the engine by setting the engine switch to the OFF position.
Hold the power tool as close as possible to your body to achieve better balance. Make sure that the tip of
the power tool do not touch the ground. Do not rush when working, rather work continuously until all the
branches on the hedge are trimmed evenly.
ATTENTION! When working, do not leave the engine idling for too long. Long term running of the power
tool at low speed will result in prematurely wearing out the gearbox. On the other hand, when trimming, it is
not good to keep the engine running at full speed for too long. Long term running of the power tool at high
speed will result in reducing the lifetime of the engine.
SETTING THE HANDLE
WARNING!
Do not use the trigger when performing this task!
When trimming hedges, to reduce work fatigue, the
rear handle can be set to the following 3 positions:
central, left at a 90° angle or right at a 90° angle.
The setting is made by releasing the lock on the rear
handle (Fig 6. point 1). Push the lock downwards
and then turn the handle in the desired direction. The
handle will remain locked in its position when the lock
is released.
Fig. 6
Starting the engine | Using the hedge trimmer - trimming