Fidelity Measurement DC-10, Руководство по эксплуатации

Страница: 35 / 97

35
10.4.1 Check types and target
Below 2 types of check target are available.
•
Quantity Check: - Check target = quantity value
•
Weight check Count: - Check target = weight value.
Average Piece Weight is the basic of all piece count transaction / process. Average Piece Weight can be created
and obtained through one of the below methods: -
a.
Direct entry method.
b.
Employ last unit weight when power on
c.
Recall from quick PLU.
10.4.1.1 Direct entry method
1.
Enter check type: -
 For quantity check, press [QTY] then press [Check] .

For weight check, press [@WT] then press [Check] .
2.
Instrument displays Low on LCD1.
3.
Enter Lo weight check limit through numeric key then press [Print/M+] .
4.
Instrument displays High LCD1.
5.
Enter Hi weight check limit through numeric key the press [Print/M+] .
6.
Instruments returns to normal operation status.
At this point, weight check limit is saved and in effect.
10.4.1.2 Employ last check type and limits when power on
Last check type and limits (before powered off) will be employed automatically when powered on again.
10.4.1.3 Recall check type and limits from quick PLU
•
For quantity check: - Refer to paragraph 11.2.2 for details.
•
For weight check: - Refer to paragraph 11.3.2 for details.
10.4.2 Hints for entering Lo and Hi limits
•
For normal comparison, set both Lo and Hi limits.
•
To check only if result is lower than or equal to Lo (result ≤ Lo), set Hi Limit = 0.
•
To check only if result is higher than or equal to Hi (result ≥ Hi), set Lo Limit = 0.
•
To check if result is equal to a specified value, set both Hi Limit and Lo Limit = the specified value.
10.4.3 Cancel check function
To clear check function, follow paragraph 10.4.1.1 and enter zero value by pressing [CE/x10] in steps 2 and
4 .
10.4.4 Check Function priority rules for dual platform (PA) operation
Instrument follows the below priority rule numbers to determine the Lo and Hi check limits for dual platform
(PA) operation.
1.
The platform with larger capacity.
2.
The platform with larger division value.
3.
P1 when both platforms have the identical capacity and division settings.