Fidelity Measurement DC-10, Руководство по эксплуатации

Страница: 28 / 97

28
8.2 Parameters Table for PC & Command & Scanner
Step
No.
Set Item Parameters PC CMD SCANER
1 Baud Rate
1200 ~ 921600 in 12 steps
Default = 115200
■ ■ ■
2 Parity
None / Odd / Even
Default = None
■ ■ ■
3 Data Length
7 / 8
Default = 8
■ ■ ■
4
Protocol Type
Note G
Protocol 0 ~ 9 & Custom
Default = Protocol 1
■ Completed Completed
5
Transmission
Interval
Note A
0 ~ 300 (second) in 10 steps
Default = 0
Completed
8.3 Parameters Table for Auto 1 ~ 3 & Manual
5
Step
No.
Set Item Parameters Auto 1 Auto 2 Auto 3 Manual
1 Baud Rate
1200 ~ 921600 in 12 steps
Default = 115200
■ ■ ■ ■
2 Parity
None / Odd / Even
Default = None
■ ■ ■ ■
3 Data Length
7 / 8
Default = 8
■ ■ ■ ■
4
Auto
Accumulation
Note B
Off / On
Default = On
■ ■ ■ ■
5
Check Control
Note C
Off / On
Default = Off
■ ■ ■ ■
6
Stability Control
Note D
Yes / No
Default = Yes
■ ■ ■ ■
7
Minimum Output
Weight
Note E
10 ~ 20d in 11 steps
Default = 20d
■ ■ ■ ■
8
Output Format
Note F
Lab 1 ~ Lab 5, LP 50, TSC and
Sbarco
Default = Lab 2
■ ■ ■ ■
9
Other
Procedures
Note H ~ K
Note A: - Transmission interval is the time interval (in second) between each output. 0 = continuous output.
Note B: - On = Auto Memory accumulation enabled.
Off = Auto Memory accumulation disabled.
Note C: - On = (When check function is in effect) Only OK value (value which is within Lo and Hi Limits) will
be transmitted.
Off = (When check function is in effect) Check control is disabled.
Note D: - Yes = Only stable weight will be transmitted.
No = Transmission is activated when [Print/M+] is pressed disregarding the weight stable status.
5
Auto 1 ~ 3 do not support PA.