63
SAFETY
ST
AR
TING UP
AND DRIVING
W
ARNING
LIGHTS AND MESSAGES
IN AN
EMERGENCY
SER
VICING
AND CARE
TECHNICAL
SPECIFICA
TIONS
INDEX
DASHBOARD AND CONTROLS
Fan speed adjustment buttons (H)
Press button
H
to increase or to decrease
the fan speed and therefore the amount
of air sent into the passenger compart-
ment, though the required temperature
remains set.
The fan speed is shown by the lit bars on
the display:
❒
Maximum fan speed = all bars lit
❒
Minimum fan speed = one bar lit.
The fan can be switched off only if the cli-
mate control compressor has been
switched off by pressing button
F-fig. 40
.
IMPORTANT To restore automatic fan
speed control after a manual adjustment,
press the button
AUTO
.
IMPORTANT At high vehicle speeds, the
dynamic effect may increase the flow of air
into the passenger compartment, which
does not directly correspond to the fan
speed bar display.
AUTO button (A)
(automatic operation)
Press the button
AUTO
to make the sys-
tem automatically adjust the quantity and
distribution of the air sent to the passen-
ger compartment. All previous manual set-
tings will be cancelled.
The wording
FULL AUTO
will be shown
on the front display in this condition.
By manually intervening on at least of the
functions automatically managed by the
system (air recirculation, fan speed or
compressor on/off), the wording
FULL
will disappear from the display indicating
that the system is no longer automatical-
ly controlling all the functions (the tem-
perature is still controlled automatically).
IMPORTANT Should the system (after
manual settings) be no longer able to guar-
antee the required temperature set in the
passenger compartment, the set temper-
ature value will start flashing to indicate
this condition, then the
AUTO
wording
turns off.
To restore system automatic control at
any time, after one or more manual ad-
justments, press the button
AUTO
.
Air recirculation on/off button (G)
The air recirculation is managed accord-
ing to the following operating logics:
❒
forced engagement (air recirculation
always on), indicated by the switch-
ing on of the LED on button
G
and
symbol
T
on the display;
❒
forced release (air recirculation
always off and intake of outside air),
indicated by the LED on the button
going off and the symbol
ê
being
displayed.
These operating conditions are obtained
by pressing air recirculation button
G
in
sequence.
IMPORTANT The engagement of the air
recirculation system makes it possible to
reach the required heating or cooling
conditions faster.
044-090 LINEA EUROPA 2ed GB:044-090 LINEA 2ed it 28-03-2012 16:21 Pagina 63
Содержание Linea
Страница 222: ...page intentionally left blank 201 226 LINEA EUROPA 2ed GB 201 221 LINEA 1ed it 28 03 2012 16 29 Pagina 221 ...
Страница 226: ...N NO OT TE ES S 201 226 LINEA EUROPA 2ed GB 201 221 LINEA 1ed it 28 03 2012 16 29 Pagina 225 ...
Страница 227: ...201 226 LINEA EUROPA 2ed GB 201 221 LINEA 1ed it 28 03 2012 16 29 Pagina 226 ...