Fiat Linea, Руководство пользователя

Страница: 22 / 234

21
SAFETY
ST
AR
TING UP
AND DRIVING
W
ARNING
LIGHTS AND MESSAGES
IN AN
EMERGENCY
SER
VICING
AND CARE
TECHNICAL
SPECIFICA
TIONS
INDEX
DASHBOARD AND CONTROLS
Setting a speed limit (SPEEd)
With this function, it is possible to set the
car speed limit (km/h or mph). When this
limit is exceeded, the driver is immediately
alerted (see section “Warning lights and
messages”).
To set the desired speed limit, proceed as
follows:
– briefly press MENU ESC – the mes-
sage (SPEEd) and the previously set unit
(km/h) or (mph) will appear on the display;
– press + or − to activate (On) or deac-
tivate (OFF) the speed limit;
– if the function is on, press + or − to se-
lect the required speed limit and then
press
MENU ESC to confirm;
Note The speed may be set in the range
from 30 to 200 km/h, or from 20 to
125 mph according to the previously cho-
sen unit (see “Setting the distance unit”)
described below. The setting will in-
crease/decrease by five units each time
+ / − is pressed. Hold the button + / −
down to increase/decrease the setting
rapidly and automatically. When you get
close to the desired value, finish the set-
ting with single presses.
– briefly press MENU ESC to return to
the menu screen or hold the button down
to return to the standard screen without
saving.
To cancel the setting, proceed as follows:
– briefly press MENU ESC : (On) will
flash on the display;
– press the button − : (Off) flashes on the
display;
– briefly press MENU ESC to return to
the menu screen or hold the button down
to return to the standard screen without
saving.
Setting the clock (Hour)
This function is used to set the clock.
To adjust proceed as follows:
– briefly press
MENU ESC – the “hours”
will flash on the display;
– press the button
+ or − for setting;
– briefly press MENU ESC − the “min-
utes” will flash on the display;
– press the button
+ or − for setting;
– briefly press MENU ESC to return to
the menu screen or hold the button down
to return to the standard screen without
saving.
Adjusting the buzzer volume
(BUZZ)
This function is used to adjust the volume
of the buzzer that sounds in the event
of failure/warning indications and when
the
MENU ESC , + and − buttons are
pressed.
To set the desired volume, proceed as fol-
lows:
– briefly press MENU ESC – the display
will show the wording (bUZZ);
– press + or − to select the required vol-
ume (adjustable over 8 levels).
– briefly press MENU ESC to return to
the menu screen or hold the button down
to return to the standard screen without
saving.
001-031 LINEA 1ed GB:001-031 LINEA 2ed it 5-11-2010 12:21 Pagina 21