Fiat 500x, Руководство пользователя

Страница: 160 / 272

IN AN EMERGENCY
158
the car, next to the symbol on the
side member itself;
143
F1B0224C
alert any bystander that the car is
about to be raised; all persons should
be kept away from the car and nobody
must touch it until it has been lowered;
use the wrench (A) to turn the jack
(clockwise) and raise the car until the
wheel is a few centimetres off the
ground;
with the wrench (A), completely
unscrew the stud bolts and remove the
wheel with the puncture;
make sure the contact surfaces
between space-saver wheel and hub
are clean so that the mounting stud
bolts will not come loose;
to simplify fitting of the space-saver
spare wheel, screw the centring pin
into the highest hole in the wheel hub
then fit the wheel, screwing on the first
stud bolt by hand for at least two turns
of the thread;
remove the centring pin and screw
on the other stud bolts by hand;
using the wrench (A), screw down all
the stud bolts;
turn the wrench (A) (anticlockwise) on
the hexagonal part of the jack to lower
the car, then extract the jack;
use the key (A) to fully tighten the
stud bolts in a criss-cross fashion as
per the numerical sequence shown in
fig. 144;
144
F1B0225C
place the punctured wheel in the
boot safely, restoring the correct
fastening, and then correctly reposition
the jack and the tools used;
replace the mat in the luggage
compartment, then return the
adjustable load platform to the level
position (see "Luggage Compartment"
section of the "Getting to know your
car" chapter);
Restore the standard wheel as soon
as possible, also because, since it
is larger than the space-saver spare
wheel, when it is placed in the relative
compartment the floor of the luggage
compartment becomes slightly uneven.
CHANGING A WHEEL
(versions with
Subwoofer)
Versions with space-saver spare
wheel
On these versions the tools for
replacing the wheel are found in a
dedicated bag inside the luggage
compartment.
In the case of puncture, proceed as
follows:
open the boot and then lift up the
mat;
unscrew the fixing device (A) fig. 145,
remove the space-saver spare wheel
(B) and fit it instead of the wheel with
the puncture, following the procedures
already described.
145
F1B0453C