Festo CAMC-G-S1, Перевод оригинальной инструкции

Страница: 34 / 50

4 Commissioning
34 Festo – GDCP-CAMC-G-S1-EN – 1412b – English
4.3.3 Display permanent diagnostic memory of the motor controller
To display or save the permanent diagnostic memory, activate the online “Diagnosis” tab in the FCT
plug-in.
If there is an active online connection, you should then activate the “Permanent” tab. “Read” reads the
number of entries of the permanent diagnostic memory specified under “Entries” and displays them in
chronological order, newest first.
Selecting “All entries” reads the complete permanent diagnostic memory. This can take several
minutes.
The content of the diagnostic memory is displayed in the form of a table:
Column Explanation
No. Sequence number of the entry.
Fault no. Error, warning or event number
è
See section 5.4.2.
Fault description Name of the entry, error text.
Timestamp Time of the diagnostic event in the format <hh>:<mm>:<ss> (operating hour
counter, duty cycle of the logic supply).
Constant Additional information for the Festo service personnel
Free parameter Additional information for the Festo service personnel
Type Type of entry (error, warning, log entry).
Tab. 4.2 Display of the permanent diagnostic memory
The following table shows some entries as examples:
No. Fault
no.
Fault description Timestamp Constant Free parameter Type
1 00-21 Log entry from the
safety module
580:15:03 0x0000 Error acknowledge, source:
0x01, error free
Fault
2 00-8 Controller switched on 580:15:00 0x0000 0x0000 Fault
3 00-11 Module change:
current module
580:15:22 0x48FF CAMC-DS-M1, S/N:
3781764777, HW rev.: 0.1,
SW rev.: 0.1
Fault
4 00-12 Module change:
previous module
580:15:22 0x4830 CAMC-G-S3, S/N:
1212820487, HW rev.: 1.0,
SW rev.: 1.0
Fault
... ... ... ... ... ... ...
Tab. 4.3 Sample entries in the diagnostic memory
Additional information on the entries in the diagnostic memory:
– Entries are made chronologically, meaning that the top entry is the most recent entry.
– Small deviations of the timestamp are possible after Power OFF/ON, as the motor
controller only saves the timestamp once per minute to non-volatile memory.