Section 3: Power Supply Operation
3.5 Control of Power Supply from TemEBeam EBC Integrated Controller
0101-8242-0, Rev. C
3-5
CV-6SLX User Manual
Figure 3-5 Operations>E-Beam Screen when Gun is On and HV is Off
3.5.4 Setting the Beam Power Level
To set the beam power level, first touch the
Change
button, then touch the
E-Beam
button.
The EBC will then display a keypad screen, which you can use to enter a percent-power
setpoint. After you do so and touch
Enter
to close the keypad, the power supply will ramp up to
that power setpoint. In Figure 3-6, the user has used the keypad to enter
Figure 3-7 shows
the Ops>E-Beam screen after the user has closed the numeric keypad, with the beam now
operating at 5% power (= 75 mA). Note that the beam power level can be set or changed either
with beam on or with it off.
Figure 3-6 Operations E-Beam Screen with Numeric Keypad Displayed
Содержание Temescal CV-6SLX
