Fellowes Standard Morgana FRN-6, Руководство по обслуживанию

Страница: 46 / 67

R O T A R Y
PAGE 44
S E R V I C E
Section 13 GUARDS
13.1..... Guard Position
Both the main guard and the exit guard are held in place by
magnets which are adjustable, to allow the guards to close
correctly.
Lateral height adjustment is achieved by screwing the magnets in
or out of their mounting blocks as required.
( A large thick blade
screwdriver may be used to turn the magnets if they cannot be
moved by hand but take care not to force them).
The gap between
the two guards should be 3mm/ 1/8”.
Angular adjustment is achieved by loosening the two M3 screws
which hold each magnet housing. It is important that the magnets
sit squarely on their keep plates - particularly on the exit guard -
and this is best achieved by setting the height first (as in the
previous paragraph) and then loosening the housing screws and
closing the guard.
The magnets should now self align, allowing the housings to be
held whilst the screws are tightened in the correct position.
Guard positioning......................................................Fig 13.11
Counter Plate
Housing Screws
Under Side Cover
Magnet
Housings
Magnet
Main (upper)
Guard
Exit (lower)
Guard
Lift Up to Open
Drop Down
to Open
Guard Safety
Switch
Actuator