Fellowes Standard Morgana FRN-6, Руководство по обслуживанию

Страница: 15 / 67

N U M B E R E R
PAGE 13
M A N UAL
-The op side manifold must be set accurately by measuring it's
position on the loading table. (Do not rely on the printed scales
because they may not be accurate enough due to limitations of
the printing process).
-Load some paper and set the clutch side manifold so that there is
no side-ways movement of the paper.
-Run a few sheets with the numbering ' ON' , and watch carefully
the edge of the sheet whilst it is feeding.
The edge should always run straight as this indicates that the
vacuum roller is correctly adjusted.
If the edge runs off to one side while the suction is on, and then
runs straight whilst the suction is off (listen to the sound of the
suction while watching the edge of the sheets), the vacuum roller
will require adjusting.
The vacuum roller assembly is set at the factory with it's
adjustment as far forward as possible (to the delivery end of the
machine).
This means that if the sheet edge runs towards the operator side,
the clutch side of the vacuum roller assembly must be adjusted
rearwards (towards the feeder end).
Conversely, if the sheet runs away from the operator side, the
operator side of the vacuum roller assembly must be adjusted
rearwards (towards the feeder end).
The vacuum roller assembly is adjusted by re-positioning the
screws (item 7) in the slots in the side-frames. The M4 nuts (item
5) under the loading table will also have to be released before
adjusting the vacuum roller assembly. (Ensure they are re-
tightened after adjustment is completed).
The feed drive timing belt may also require adjustment (See
section 3.4).
Note ....... Don’t attempt to stretch the drive belt over pulley
flanges.
Section 3 SUCTION FEED