Fellowes Standard Morgana FRN-6, Руководство по обслуживанию

Страница: 39 / 67

N U M B E R E R
PAGE 37
M A N UAL
Section 10 MAIN PRINT SHAFT
Note ....... Always support the shaft and use a hub puller to remove
the operator-side bearing from the shaft and take care
not to lose the keys from the collars
10.2 .... Main Print Shaft - Re-assembly
The main print shaft is replaced in reverse sequence, but make
sure the collars are the right way round or you won’t be able to set
the numbering heads. Also make sure that the thrust washer is
placed over the shoulder on the main shaft before replacing the
bearing.
To fit the operator side bearing without damage, special tool T040
should be used as shown in fig 10.21 below. The tool is fitted over
an M6 bolt which is screwed into the tapped hole in the end of the
main shaft. The nut is then tightened to press the bearing into
position.
Remove the special tool and finally replace the circlip, the bearing
plates,and all the other items removed (not forgetting the ink drive
Bearing Replacement - Print Shaft ............................ Fig 10.21
M6 Nut & Set Screw
Special Tool Bearing Thrust Washer
M6 Tapped Hole (in End of Print Shaft)
Principle Bearing Housing (Operator Side)