Felder G 500, Руководство пользователя, Страница: 45 / 84

45
Maintenance
Edgebander
G 500
9 Maintenance
As part of the maintenance works the whole machine as
well as ist safety devices must be checked regularly for
damage. Screws, nuts and connected parts must also be
checked for fit at regular intervals.
Abide by the laws of the country in which the machine
is used regarding the disposal of products used to clean
and maintain the machine, and heed the manufacturer’s
advice with regard to recommended products.
Attention! The guarantee becomes invalid in the case of incorrect maintenance.
9.1 Safety instructions
Warning! Risk of injury: Improper maintenance can cause serious injury or damage. For this reason this
work may only be carried out by authorised, trained personnel who are familiar with the operation of the
machine and in strict observance of all safety instructions.
• Before beginning any maintenance work on the machi-
ne, switch it off and secure it against accidentally being
switched on again. Also the pneumatic feed has to be
switched off.
• The pressure vent must be set to the „release pressure“
setting.
• Ensure that there is sufficient space to work around
the machine.
• Suitable protective clothing must be worn during
cleaning and maintenance work (see 2.7 Personal
safety).
• Keep the work area orderly and clean. Components
and tools that are not put in their correct place or put
away may be the cause of accidents!
• Following the maintenance work, re-install the guards
and check that they are functioning properly.
Warning! Danger – electric current: Work on electrical fittings may only be carried out by qualified person-
nel and in strict observance of the safety instructions.
Attention! Take notice of the suitability of the recommended oils!
Warning! Risk of injury! Be aware that the glue has an operational temperature of 200° C during filling
and re filling, periodic maintenance and whilst cleaning the glue pot. Use all suitable methods of protection
to prevent severe injury. The used glue must be disposed of according to regulations on the installation site
of the machine.