Feig Electronic TST FUZ2, Руководство по сборке

Страница: 75 / 96

TST Assembly instructions FUZ2 -A/-B/-C/-CX/-G/-L
FEIG ELECTRONIC GmbH Page 75 of 96 TST_FUZ2-A-B-C-CX-G-L_Montageanleitung_EN_22.docx
No. Description Possible reason for error
F.033 Bad position transmitter
protocol
• Fault on the position transmitter
• No position data available over an extended period
F.043 Pre-limit switch fault (light
barrier)
• The pre-limit switch for the light barrier remains activated even in the middle end position or upper end position.
F.060 Breakaway recognized
• Breakaway was detected but not fixed
• The automatic lead in after breakaway has failed
F.063 Balance error on loop 3
• Disturbed environment
• Loop outside the tolerance range
F.064 Balance error on loop 4
• Disturbed environment
• Loop outside the tolerance range
F.067 Error on loop 3
• Shortcut or intermitted loop connection wirering
F.068 Error on loop 4
• Shortcut or intermitted loop connection wirering
F.080 Maintenance is required
• Service counter has expired
F.090 Controller not parameterized
• The min. necessary basic parameters for the controller have not yet been set → Activate DIP-switch and put in the
asked parameters.
F.101 Message from sensor-actor-
interface:
An unknown or incompatible
device was detected on the
CAN or RS485 bus. The
controller is not able to identify
it and assign it to a device class
(detector, light curtain, etc.).
• The serial number of the connected device is not known --> Replace device.
• The software version or protocol version is incompatible --> Update the control software.
F.102 Faulty CAN bus due to faulty
telegrams.
• Poor CAN wiring
• Missing ferrites on the motor cable
• Missing terminating resistors for CAN bus termination
• CAN lines too long (180m)
• Faults on the CAN line when the door operator is moving
F.103 CAN BUS is faulty. The error
acknowledges itself
automatically if the CAN BUS is
not faulty.
•Short circuit of The CAN Low and CAN High lines
•A device on The CAN bus interferes with The bus due to faulty telegrams.
•non terminated CAN bus
F.104 The maximum number of
permitted devices (16) on the
CAN bus has been exceeded. There are too many devices on the CAN bus