Feider Machines FSOR17210, Руководство пользователя

Страница: 21 / 29

21
9. MAINTENANCE
Warning! Prior to any adjustment, maintenance or service work disconnect the mains power plug!
9.1 GENERAL MAINTENANCE MEASURES
Wipe chips and dust off the machine from time to time using a cloth. In order to extend the service life of the
tool, oil the rotary parts once monthly. Do not oil the motor.
When cleaning the plastic do not use corrosive products.
If the supply cord of this power tool is damaged, it must be replaced by a specially prepared supply cord
available through the service organization.
9.2 CLEANING THE MOVING SAW BLADE GUARD SAFETY
DEVICE (5)
Always check the saw blade guard for debris before using the machine.
Remove old sawdust and splinters using a brush or similar tool.
9.3 REPLACING THE TABLE INSERT
Danger!

With a damaged table insert (10) there is a risk of small parts getting stuck between table insert and saw
blade, blocking the saw blade. Immediately replace damaged table inserts!
a) Remove screws at table insert. If required, turn rotary table and incline saw head to be able to reach
the screws.
b) Remove table insert.
c) Install new table insert.
d) Tighten the screws at table insert.
9.4 BRUSH INSPECTION
Check the carbon brushes after the first 50 operating hours with a new machine, or when new brushes have
been fitted. After carrying out the first check, repeat the check every 10 operating hours.
If the carbon is worn to a length of 6 mm, or if the spring or contact wire are burned or damaged, it is
necessary to replace both brushes. If the brushes are found to be usable following removal, it is possible to
reinstall them.
When servicing the carbon brushes, open the two latches counterclockwise (as shown in Figure 21).
Then remove the carbon brushes.
Replace the carbon brushes in the reverse order.
10. STORAGE
Store the device and its accessories in a dark, dry and frost-proof place that is inaccessible to children.
The optimum storage temperature is between 5 and 30˚C.
Store the electrical tool in its original packaging.
Cover the electrical tool in order to protect it from dust and moisture.
Store the operating manual with the electrical tool.