Feider Machines FSOR17210, Руководство пользователя

Страница: 16 / 29

16
identical to the mains data.
6.1 CHECKING THE MOVING SAW BLADE GUARD SAFETY
DEVICE (5)
The saw blade guard protects against accidental contact with the saw blade and from chips flying around.
6.2 CHECK FUNCTION
To do so, fold the saw downwards:

The saw blade guard must provide free access to the saw blade without touching other parts.

When folding the saw upwards into the starting position, the saw blade guard must cover the saw blade
automatically.
7. ATTACHMENT AND OPERATION
7.1 ATTACHING THE CROSSCUT, DRAG AND MITRE SAW
(FIG.1/2/4/5)

In order to adjust the rotary table (14), loosen the handle (11) approximately 2 turns and pull up the
latched position lever (36) with your index finger.

Turn the rotary table (14) and pointer (12) to the desired angle measurement on the scale (13) and use
the handle (11) to secure it.

Pressing the machine head (4) lightly downwards and removing the locking bolt (23) from the motor
bracket at the same time disengages the saw from the lowest position.

Swing the machine head (4) up.

It is possible to secure the clamping devices (7) to the left or right on the fixed saw table (15). Insert the
clamping devices (7) in the holes on the rear side of the stop rail (16) and secure it with the star grip
screws (7a). For 0°- 45° mitre cuts, the clamping device (7) must only be mounted on the right side (see
fig. 11-12).

It is possible to tilt the machine head (4) a max. 45° to the left by loosening the set screw (22).

Workpiece supports (8) must always be secured and used during work. Set the desired table size by
loosening the set screw (9). Then tighten the set screw (9) again.
7.2 PRECISION ADJUSTMENT OF THE STOP FOR CROSSCUT
90° (FIG. 1/2/5/6)

No stop angle included.

Lower the machine head (4) and secure it using the locking bolt (23).

Loosen the set screw (22).

Position the angle stop (A) between the saw blade (6) and the rotary table (14).

Loosen the lock nut (26a).

Adjust the adjusting screw (26) until the angle between the saw blade (6) and rotary table (14) is 90°.

Re-tighten the lock nut (26a).

Subsequently check the position of the angle indicator. If necessary loosen the pointer (19) using a
Philips screwdriver, set to position 0° on the angle scale (18) and re-tighten the retaining screw.