Feider Machines FSOR17210, Руководство пользователя

Страница: 19 / 29

19

Open the set screw (16b) for the moveable stop rail (16a) and push the moveable stop rail (16a)
outwards.

The moveable stop rail (16a) must be fixed far enough in front of the innermost position that the distance
between the stop rail (16a) and the saw blade (6) amounts to a minimum of 8 mm.

Before making a cut, check that the stop rail (16a) and the saw blade (6) cannot collide.

Re-tighten the set screw (16b).

Move the machine head (4) to its upper position.

Release the rotary table (14) by loosening the handle (11).

Using the handle (11), set the rotary table (14) to the desired angle (refer also to point 8.4 in this regard).

Re-tighten the handle (11) to secure the rotary table (14).

Undo the set screw (22).

Use the handle (1) to tilt the machine head (4) to the left until it coincides with the required angle value
(in this connection see also section 7.6).

Re-tighten the set screw (22).

Cut as described under section 7 .3.
7.8 LIMITING THE CUTTING DEPTH (FIG. 3/13)

The cutting depth can be infinitely adjusted using the screw (24). To do this loosen the knurled nut (24a)
on the screw (24). Turn the screw (24) in or out to set the required cutting depth. Then re-tighten the
knurled nut (24a) on the screw (24).

Check the setting by completing a test cut.
7.9 SAWDUST BAG (FIG. 1/22)

The saw is equipped with a debris bag (17) for sawdust and chips. Squeeze together the metal ring on
the dust bag and attach it to the outlet opening in the motor area. The debris bag (17) can be emptied by
means of a zipper at the bottom.

Connection to an external dust extractor
a) Connect the vacuum hose with the dust extraction spout.
b) The industrial vacuum cleaner must be suitable for the material being worked.
c) When vacuuming dust that is especially detrimental to health or carcinogenic, use a special vacuum
7.10 CHANGING THE SAW BLADE (FIG. 1/2/14-17)
Remove the power plug!
Important!
Wear safety gloves when changing the saw blade.
Risk of injury!

Swing the machine head (4) upwards and lock with the locking bolt (23).

Loosen the retaining screw (5a) of the cover using a Philips screwdriver. WARNING! Do not fully
remove this screw.

Fold the saw blade guard (5) upwards until the saw blade guard (5) is above the flange screw (28).

With one hand insert the Allen key (C) in the flange screw (29).

Hold the Allen key (C) and slowly close the saw blade guard (5) until it touches the Allen key (C).

Firmly press the saw shaft lock (30) and slowly rotate the flange screw (28) in clockwise direction. The
saw shaft lock (30) engages after no more than one rotation.

Now, using a little more force, slacken the flange screw (29) in the clockwise direction.