Feider Machines FSOR17210 Скачать руководство пользователя

Страница: 7 / 29

Periodically check that all fasteners, screws, bolts and nuts are properly tightened.

Do not put materials or equipment above the saw to prevent the possibility of an unfortunate fall.

Use the saw to cut parts that are insulated from electricity. If you accidentally cut a wire hidden in

the workpiece or cut the power cable of the saw, the metal parts of the saw are covered by the

current, the power must then be switched off immediately and the plug removed from the saw
outlet.

Never use the saw near any flammable liquid or gaseous material.

Note and remember the direction of rotation of the motor and that of the blade.

Do not block the movable blade guard in the open position and make sure it can move freely and
fully cover the blade teeth.

Place a saw on a dust collecting bag and ensure it is working properly. As an operator, you need

to know the factors that influence the severity of pollution, such as material type, performance,
and setting of the dust collection or evacuation device. In any case we recommend the use of a
dust mask.

Wear gloves when handling saw blades and rough materials.

Put the saw blades in a sheath during transport.

Select the saw blades according to the type of material to be cut.

Use sharp saw blades and observe the maximum speed marked on the blade.

Redouble your attention by machining a groove.

The miter saw can be transported safely by the main handle, but only when it has been

disconnected from the power outlet and locked in the locked position.

Do not use the saw when the guards are not properly assembled, in good condition or well

maintained.

Make sure that the arm is securely secured during bevel cutting.

Apply the workpiece strongly against the swivel table on which there should be no other pieces

of wood.

Ensure that you have received training and / or training and know how to adjust and use this tool.

Use blades that are properly sharpened and do not exceed the maximum rated speed.

Do not pick up debris from the cutting area until the blade guard closes and the saw is

completely stopped.

Attach the miter saw to a workbench if possible.

When cutting a long piece that extends far beyond the width of the table, supports should be

used to support the ends of the workpiece at the same height as the cutting table. The supports
must be positioned so that the workpiece does not fall to the ground when the cutting has

finished. If the part is very long, several supports must be provided.

Use only a saw blade diameter in accordance with the markings on the saw.

Use only saw blades that are marked with a speed equal or higher than the speed marked on

the tool.

Adjust the saw for proper cutting capacity, if applicable.

If adjustable and/or removable workpiece support extensions are provided always fix and use
these extensions during operation.

Avoid overheating the saw blade tips. Long periods of use can overheat the blade. Take breaks

of about 15 minutes to let the tool cool.

- Always check if the saw blade guard is working properly. It shall be well assembled, and it shall

be easily moving with hand and that it can be locked when operating the tool (see in
instructions for use).

- Avoid to melt plastic during the cutting.

If the supply cord of this power tool is damaged, it must be replaced by a specially prepared supply
cord available through the service organization.