![background image](http://html.mh-extra.com/html/federal-signal-corporation/pagasys-gen-ii-p-sys-g/pagasys-gen-ii-p-sys-g_description-installation-operations-and-maintenance-manual_548461043.webp)
43
I/O and Terminal Block Cards
Description, Installation, Operations, and Maintenance Manual
Federal Signal www.fedsig.com
The Access Panel Aggregator I/O card provides termination points for Access Panels. See
list of models with attributes below.
Table 24 Termination Points
Model
Number of Access
panels supported
AP Field Connection Type
P-APIC-G
4
Cage clamp terminal block
P-APIC-G-01 4
Screw terminal block
P-APIC-G-02 8
RJ45
The P-APIC-G is a microcontroller-based card assembly that acts as a communication
hub with its connected Access Panel, continually gathering and collating the status of
each Access Panel keypad button and conveying the required state of each Access Panel
keypad LED to the Access Panel’s on-board microcontroller.
The System Controller receives the collated Access Panel keypad button status data from
P-APIC-G(s) and defines the required state of each Access Panel LED to the P-APIC-G
card.
How the PAGASYS GEN II system reacts to an Access Panel button press is solely
controlled by the PAGASYS GEN II System Controller and is dependent on the overall
system configuration and priorities.
NOTE
: The service model for the standard Access Panel Aggregator I/O card is
K-P-APIC-G.
Figure 21 Access Panel Aggregator I/O Card, RJ45 Connector (P-APIC-G)
Port 1
4052
LED Reg
Port 2
4058
Port 3
405E
Port 4
4064
Port 5
406A
Port 6
4070
Port 7
4076
Port 8
407C