![background image](http://html.mh-extra.com/html/federal-signal-corporation/pagasys-gen-ii-p-sys-g/pagasys-gen-ii-p-sys-g_description-installation-operations-and-maintenance-manual_548461064.webp)
64
Removing and Installing the Controller Chassis
PAGASYS GEN II (P-SYS-G)
Federal Signal www.fedsig.com
Figure 37 Card Guides in Controller Chassis
2. Carefully press the internal card in vertically downward to mate it with its backplane
connectors.
3. Once all internal cards have been installed in their correct locations, refit the
Controller Chassis top cover and refit the top cover retaining screws.
5.2.3 Installing the Controller Chassis
To install the Controller Chassis:
1. Temporarily secure all cables out of the way to allow the Controller Chassis to slide
into its vacant cabinet position.
2. Carefully slide the Controller Chassis into the Cabinet ensuring that no cables are
pinched in the process.
3. Tighten the front retaining screws.
4. Plug all the cables into their correct positions. (See the next section, Installing the
Controller Chassis cables.)
5. Attach the front cover, using three slots on the left side as hinges and carefully
closing like a door on the right side, until the latch clicks in position.
5.2.4 Installing the Controller Chassis Cables
See the PAGASYS GEN II System Controller Technical Installation Guide for detailed
specifications on Controller card wiring connections.
To connect the Controller Chassis cables to the Chassis:
1. After the Controller Chassis is installed in the cabinet (see prior section, Installing
the Controller Chassis), and before the front cover is attached, install the cables.
2. Plug the following cables into the RJ45 jack sockets located on the I/O Interface
card.