![background image](http://html.mh-extra.com/html/federal-signal-corporation/pagasys-gen-ii-p-sys-g/pagasys-gen-ii-p-sys-g_description-installation-operations-and-maintenance-manual_548461014.webp)
14
Safety Messages
PAGASYS GEN II (P-SYS-G)
Federal Signal www.fedsig.com
1.0 Safety Messages
This equipment should be installed, adjusted, and serviced by qualified technicians
familiar with the construction and operation of the equipment and the hazards
involved.
Read, understand, and follow all of the warnings provided in the Safety Messages
section of this instruction manual, before servicing the system. Failure to do so could
result in personal injury, bodily harm, or death to you or others.
Shock Hazard Warning
Hazardous voltages applied to the Controller Chassis may cause severe injury or
death. Verify AC and DC power is disconnected before performing installation or
service procedures.
Static Protection Notice Warning
The printed circuit cards used in this equipment contain static sensitive components.
Observe the warnings listed below to prevent damage to these components.
Disregarding any of these warnings may result in personal injury or damage to the
equipment.
• Strictly adhere to the procedures provided in this document.
• Before touching any static sensitive component or printed circuit card containing such
a component, discharge all static electricity from yourself by wearing a wrist strap
grounded through a 1 Megohm resistor.
• Do not touch the traces or components on a printed circuit card containing static
sensitive components. Handle the printed circuit card only by the edges that do not
have connector pads.