13
Installation
Signaling Standalone Manual
Federal Signal
www.fedsig.com
5.
Loosen the pivot bolts to provide the direction of the speaker.
Attaching the Mounting Brackets to the Speaker Housing
Do the following to attach the brackets:
1.
The mounting brackets are attached to the speaker as shown below using the six
supplied 1/4-20 by 5/8-inch screws.
Note the orientation of the curved slots on the L-shaped brackets; this orientation is
important to allow the speaker to be pivoted downward.
2.
Tighten the 1/4-20 by 5/8-inch screws to approximately 80 in-lb.
3.
Attach the U-shaped wall bracket with four supplied sets of 3/8-16 by 1-inch bolts, flat
washers, lock washers, and nuts.
Figure 2 Bracket attached to speaker
1/4-20 x 5/8" screws (6)
3/8-16 x 1" bolts (4)
Note the orientation
of this curved slot
with respect to the
"FS" on the side of
the housing.
Figure 3 Width and height of bracket
2.00 in
5.00 in
2.88 in
1.44 in
5X .397
