12
Installation
Informer100 Speaker (Models IS-I-IP100ACX and IS-I-IP100DCX)
Federal Signal
www.fedsig.com
Table 4 Environmental and Physical
Operating temp range
-40°F to +104°F (-40°C to +40°C)
Humidity range
0-95%, non-condensing
Size
(Height x Width x Length)
7 x 9 x 10 inches (178 x 229 x 254 mm)
Weight
I-IP100DCX
I-IP100ACX
16.2 lb (7.35 kg)
19.2 lb (8.71 kg)
Table 5 Hazardous Location Ratings
T-CODE AT 40°C
CLASS I, DIV 2, GRPS A,B,C,D
T5
CLASS II, DIV 2, GRPS F,G
T6
CLASS III
T6
Installation
Read and adhere to all safety warnings in this manual before installing the
Informer100 Speaker.
Electrocution or severe personal injury can occur when making electrical
connections, drilling holes, or lifting equipment. Therefore, experienced
electricians, in accordance with national and local electrical codes, acting under
the direction of the installation crew safety foreman, should perform installation.
Determine a Suitable Location
The Informer100 can be mounted on any relatively flat surface with the supplied mounting
brackets. The mounting surface must be capable of supporting the weight of the speaker.
This equipment is suitable for use in Class I, Division 2, Groups A, B, C, D; Class II, Division
2, Groups F and G; Class III or nonhazardous locations only.
Wall Mounting
The Informer100 Speaker comes standard with a bracket for vertical wall or pole mount
with optional pole accessories. The standard mount can be flipped to allow ceiling mount.
To wall mount the Informer100 Speaker, do the following:
1.
Find a suitable location to mount the speaker. Use industry- or company-preferred
practices when mounting hardware to structures.
2.
Verify that the mounting is adequate to hold the weight of speaker, cables, and visual
devices, if equipped.
3.
Refer to Figure 3 or use the U-shaped wall bracket as a template to scribe the
mounting hole locations.
4.
Mount the Informer100 Speaker to the mounting surface with user-supplied hardware.
Federal Signal recommends 3/8 inch fasteners.
