Fayat Dynapac CC900G, Инструкция по эксплуатации

Страница: 39 / 104

Operation
Ensure that there is good ventilation (air
extraction) if the engine is run indoors. Risk of
carbon monoxide poisoning.
31
4812274432.pdf 2017-07-10
Starting
Starting the engine
Figure. Control panel
1. Starter switch
2. Speed control
3. Parking brake
6. Forward/Reverse lever
11. Choke
Make sure that the parking brake knob (3) is activated.
Sit down in the operator's seat and set the
forward/reverse lever (6) in neutral. You cannot start
the petrol engine with the lever in any other position.
Set the RPM control (2) to idle.
For cold start: Pull out the choke (11) and turn the
ignition key to position II. Check that the warning
lamps on the control panel are working. Turn the
ignition key (1) to the right. As soon as the engine has
started, release the ignition key.
Do not run the starter motor for too long. If the
engine does not start immediately, wait a minute
or so before trying again.
Do not run the starter motor for too long. If the
engine does not start immediately, wait a minute
or so before trying again.
Warm up the engine at idling speed for a few minutes,
although longer if ambient temperature is below +10 C
(50 F)
When the engine is warm, check that the parking brake
warning lamp (12) is still lit.
When starting and driving a machine that is cold,
remember that the hydraulic fluid is also cold and
that braking distances can be longer than normal
until the machine reaches the working temperature.
When starting and driving a machine that is cold,
remember that the hydraulic fluid is also cold and
that braking distances can be longer than normal
until the machine reaches the working temperature.
Ensure that there is good ventilation (air
extraction) if the engine is run indoors. Risk of
carbon monoxide poisoning.
11
3
1
6
2
Fig. Instrument panel
12. Parking brake warning lamp
12