Fayat Dynapac CC900G, Инструкция по эксплуатации

Страница: 104 / 104

Maintenance - 2000h
The water tank is made of plastic (polyethylene)
and is recyclable.
96
4812274432.pdf 2017-07-10
Front drum - Changing the oil
Fig. Drum, Drive side
1. Oil plug
2. Position for level check
1
2
Loosen the oil plug (1) slightly, when it is in position for
level check (2), so that it can subsequently be
unscrewed by hand.
Park the roller on a level surface, and drive the roller
slowly until the plug (1) is in the bottom position.
Switch off the engine, disconnect the power and
push in the reserve/parking brake knob.
Switch off the engine, disconnect the power and
push in the reserve/parking brake knob.
Place a receptacle that will hold at least 4 liters (1 gal)
under the plug.
Remove the plug (1) and let the oil run out.
Deliver the drained oil to special waste handling. Deliver the drained oil to special waste handling.
See under the section 'Every 500 hours of operation'
for filling oil.
Water tank - Cleaning
1
Fig. Water tank
1. Cap
Keep in mind that there is a risk of freezing in
winter. Drain the tank, pump and lines.
Keep in mind that there is a risk of freezing in
winter. Drain the tank, pump and lines.
Empty the tank.
Clean the tank with water and a suitable detergent for
plastic surfaces.
Fill the tank with water and check that the sprinkler
works.
The water tank is made of plastic (polyethylene)
and is recyclable.